Make sure it matches the IP for your host-only adapter.) (I'm assuming 192.168.56.101 because that's VirtualBox's default. To get the static IP address working temporarily, access the termainal on the client, and enter the following to assign a static IP to eth1. Enable the adapter, set it to a "Host-only Adapter", and select the adpater you created above. Go to the "Network" tab, and select "Adpater 2". ![]() Next, assign this host-only adapter to the virtual machine. (Feel free to set the IP address as well, if you like.) Modify the host-only network, and disable DHCP. Go to the "Network" tab, and addd a Host-only Network. ![]() To create a host-only connection in VirtualBox, start by opening the preferences in VirtualBox. (NAT is the default, so shouldn't require any setup.) The second is a "host-only" connection that allows my host and guest to interact. The first uses NAT to allow the box to communicate with the outside world through my host computer’s network connection. ![]() My typical setup for a development box in VirtualBox uses two NICs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |